428 Part numbers and illustrations are for identification only © 1971 - 2010 w.d. armstrong corp. CUT-TO-FIT MAGNETIC GASKET KITS WITH FACTORY WELDED CORNERS FOR OVER & UNDER OR SIDE BY SIDE REFRIGERATOR DOOR GASKETS 2213 2204 The  new  design  with  "Corner  Formers".  Each  kit  contains,  two "Corner Formers", two "L" shaped pieces of gasket material and a 16' roll of magnetic material. Only two cuts are required for solvent welds. Magnetic strips are cut to size and inserted into the gasket pieces. "Corner Formers" installed in the two corners provide for sta- bility and alignment for your solvent welds. Two kits are available. Maximum Door Size 36"x 68" MEASURE DOOR & ORDER SMALLEST KIT THAT WILL FIT MAGNET AND INSTRUCTIONS INCLUDED Description Part No. Max. Size Wide Flap, 2001 20" X 32" Mounting Screws 2002 32" X 42" Pierce Gasket 2003 32" X 55" Flap 2004 37" X 84" 2005 22" X 72" Narrow Flap, 2301 20" X 32" Mount with 2302 32" X 42" Clips or Long 2303 32" X 55" Retainer Strips 2304 37" X 84" 2305 22" X 72" Two Piece Gasket Kit with Corner Formers GA065 GA065 METAL RETAINER Replacement for Admiral 95065-1 & RA95113-1 Metal retainer to repair broken or split plastic liners on all makes of refrigerators.  Remove screw from broken area. Install retainer and use old screw to hold in place.  Made of stainless steel to prevent rusting.  10 per pack. CRACKED LINER PATCHING TAPE Drill Holes at End Of Crack 25" long Tape 482395